Electric forklift battery maintenance method

　　Author ：Iflowpower – Portable Power Station Supplier

1. Check before charging, the forklift battery is not intact, the wiring is not intact, and open the air cover. Do not open or dial out the liquid plug on the battery charge or charge the electricity 1, before charging, the forklift battery is not intact, the wiring is not intact, and open the air cover.

Do not open or dial out of the battery, do not add the battery near the battery or when charging the battery. It is not possible to charge the battery when the battery cannot simultaneously discharge the battery when charging is charged. Do not repair the battery when charging the battery when charging The electrolyte temperature is below 55 ¡ã C 2, such as the new forklift battery, which will be cooled to an electrolyte of 1.

26 to 30 ¡ã C to 30 ¡ã C, inject the battery, and the injection amount is 10-20 mm higher than the protective plate, waiting for 6 hours. The liquid temperature drops to 35 ¡ã C can start charging. The electrolyte specific gravity of the electrolyte refers to 30 ¡ã C, and the different temperature should be converted according to the following formula: D30 ¡ã C = DT + 0.

007 (T-30 ¡ã C) 3, the electrolytic liquid temperature should not exceed 55 ¡ã C during charging, otherwise reduce Small charging current, artificial cooling or suspend charging measures. 4. 5, when the single voltage dropped to 1.

7V, the voltage meter voltage 41V (driving load), the electrolysis specific gravity decreases to 1.18 to charge in time. 6, when the battery charges, the electrolyte specific gravity is 1.

26 with distilled water or a specific gravity of 1.4, and the electrolyte is 1.26 and maintains a sufficient height.

Battery charging start end should be used as voltage electrolyte specific gravity record. Record will help the battery maintenance and protection decomposition. 7, battery not near fire source and heat source.

After the charging is completed, the gas cover is covered, and the electrolyte is wiped out, keep the joint clean and dry, and apply Vaseline. Battery rinsing is not to hang away. 8, the battery charging environment is not well ventilated.

Especially with the car, we must forcentive. The ventilation equipment of the battery is not good, the temperature is not higher than 40 ¡ã C, and the air flow can be calculated to prevent the battery charge, the accumulation of hydrogen-oxygen mixed gas causes an explosion, and can be calculated by the following formula: q = 0.05in (where Q: air flows Quantity, I: Charge the final charging current, N: Battery unit number), should ensure that the amount of air flow between the charging is greater than the air flow in the calculation.