How is the battery not activated? Is the car battery fail to repair electricity?

　　Author ：Iflowpower – Portable Power Station Supplier

The battery is not in our lives. It is a very common thing. The battery can not enter the electricity because the electric car is not riding for a long time, and the battery can't be used for a long time, then the battery is not How to activate? This article is a small series to analyze the battery.

How to activate the battery charge, the car battery does not enter the electricity can repair, let's take a look. How is the battery not activated? How is the battery not activated? Here is a way to summarize the activation of the battery chargeable. Its operation is based on your own battery, find a good car of the same battery to peel the wire behind the charging port and pick up the red line, the black line pick the black line, then the good electric car is inserted with the charger for 20 minutes to observe the battery.

Is it hot, if you spread out of the charger to charge for 20 minutes in 1 hour, so that you can use your own charger and then charge it. However, if you have to pay attention to it, you can't charge more than 4 hours, then you can charge it twice, so you can use it. How to activate 2, first check that the battery is not lack of water, if the water is short of water, charging the 1/10 of the rated charging current until the femoral capacity is discharged with a rated capacity, until After finishing, so after three or four cycles, you can fix it.

How to activate 3, use high-power charger charge, use a large current charge, the battery is hot, there is no charge, and the temperature will continue to charge, continue to persist in 2 to 3 days, there is a certain Probability can be activated. However, these these are only suitable for comparing new batteries. If it is an old battery, it is generally reimbursed.

After all, the battery is lost, and the life will shorten by 80%. Moreover, if the battery's loss is more serious, then it can't use it closely to activate the battery, but only by changing the battery can handle the charging problem. Automotive battery can not advance electric energy repair? The battery used in the car is a lead-acid battery.

If it does not enter the electricity, the important role is caused by polar vulcanization. With regard to a battery (more than three years), it is basically no repair. It is better to replace it; if it is a battery that is shorter, the polar is light caused by over-discharge in a short time.

Devilulization, can be used to repair the vulcanized charging method to repair, but the capacity of the battery can only return to 80% of the rated capacity. The battery fluvine is a polarized electrode depositing excessive sulfate, causing an increase in the internal resistance of the battery, and the amount of capacity decreases. Its performance is that the battery is lowered when the battery is discharged; and the voltage rises so far during charging, the battery temperature is rapidly increased, but the density has slowed slowly, and there is a bubble.

For example, when the car started, the first is very powerful, then it will bring the start of the start, or the time of the car is parked more than one day, etc., etc. If you measure the voltage of the battery when you start the car, you will find that the voltage of the battery is rapidly reduced to 10V below 10V.

Such a battery can basically be determined to be vulcanized. The importance of battery vulcanization is a short time high current discharge, such as repeated start engine, listening to music after parking, using lighting, etc. With regard to mild vulcanization, it can be recovered by small electric growth.

About serious vulcanization, repair, it is more troublesome. To put all the electrolyte in the battery, then clean it with distilled water, then add distilled water, charge the small current long time to charge, when the density of the electrolyte rises to a certain value, the electrolyte is released, and then the distilled water is continuously charged. Thus, after two or three times, the density of the electrolyte no longer rose, and then discharges at a certain current, then continuous charging.

This process of charge and discharge is two to three times, and then adjust the density of the electrolyte to a suitable value, the battery is basically repaired. It can be seen that the vulcanized battery is repaired is very troublesome, on the one hand, some professional equipment and expertise, on the other hand, the time is very long, two or three days. In the operation, it is necessary to pay attention to safety.

The important ingredients of the electrolyte are sulfuric acid, with strong corrosive, and the hydrogen and oxygen are released during charging, and the flow of sparks and the danger of fire explosion. Personal proposal is to replace the vulcanization battery. If you want to fix it, you must find a professional store to solve it, don't take it yourself.

The above is how the battery is the battery that is parsed for everyone. How is the battery? It is best to overflow. .