UPS power battery change iron lithium battery How to change?

　　Author ：Iflowpower – Portable Power Station Supplier

UPS power storage battery change iron lithium ion battery How to change? Lead-acid battery has always been a standard storage power supply in the UPS field before the lithium-ion battery, but its high energy consumption, high pollution, resource, etc. have always been the pain point for its application. Nowadays, the technical development of lithium-ion batteries has been constantly breaking through high energy, low pollution, universality, etc.

, which also makes it constantly eliciting the market share of lead-acid batteries. However, lithium-ion battery technology is just a rapid development in recent years. Whether it is still in the past, lead-acid UPS generally has a lot of weight.

Moreover, the cost price of the UPS device is not cheap, and the external device is not easy to fail. The UPS is important to replace the internal energy storage power, because the energy storage power supply has the service. When the lead-acid battery life is in the UPS, the UPS device itself is good? About this problem, most people choose to replace the same type of lead-acid battery, but there is a part of the people like Do it yourself, want to replace the lead-acid battery into a ferric lithium-ion battery.

The important content of this article is to write some of the people who like to do it. Replace the lead-acid battery in the UPS power supply into a ferric lithium-ion battery, this action is not as simple as most people think, not simple series parallel lithium-ion battery, then connect with UPS is negatively connected like this. UPS power supply lead-acid battery changes Method 1 of ferric lithium ion battery 1, capacity calculation for lithium ion battery changes, the most beginning to do battery capacity calculation.

According to the capacity of the original lead-acid battery, the capacity of the lithium ion battery to be replaced is calculated, although the volume of the lithium ion battery is less than the lead-acid battery under the same capacity, but do not think of using the original UPS equivalent lithium ion battery for replacement This behavior is not very recommended. 2. Lithium-ion battery packs are usually in the case of just a lithium-ion battery equal to the capacity of the original UPS lead-acid battery is not an easy task.

Under normal circumstances, it is necessary to make a single small capacity of the lithium-ion battery to form a lithium ion battery pack for the operation of the single small-capacity lithium-ion battery. This is the best for the alternative to the lead-acid battery in a single lithium ion battery pack to perform lead acid batteries. Lithium ion battery pack 3, after the lithium ion battery pack assembly, in order to safely think of multiple detection of lithium-ion battery packs.

After detecting the safety of the lithium ion battery pack, after the replacement of the lead-acid battery, it is also possible to detect, in order to safe think, more tests are always correct. 4. The rectification is made in a number of tests.

After confirming that the lithium-ion battery pack is replaced by lead-acid battery, the last set is performed. Re-assemble the UPS according to the correct method, restore the integrity of the appearance, and finally perform the overall detection, after the detection is complete, it can be considered true completion. Although Xiaobian is a simple introduction to this behavior of the UPS voltage lead-acid battery changes, this behavior, Xiaobian is still not recommended, especially about the knowledge of this aspect.

People. Although you can save your own cost and get a sense of success, this battery is replaced with the safety of the battery, but if there is a mistake during the operation, it will have a lot of possibilities. And the surrounding environment causes greater losses, so before planning such operation, I hope everyone can think three.