How to install and replace the UPS power battery?

ଲେଖକ: ଆଇଫ୍ଲୋପାୱାର - Furnizor centrală portabilă

How to install and replace UPS power battery? According to our battery installation step, safely remove the old UPS power battery and install new / replaceable battery. 1. Insert the generator output line to the spare-electric connector, start, first let the generator run for a while.

2, open the battery cabinet, find the output line connected to the UPS power host and confirm the good, negative. 3, confirm that the generator is running stable, after the voltage is measured normally in the distribution cabinet, the switching switch is turned to the generator side, observed and determined the UPS power battery host to operate normal, and then disconnected the UPS battery cabinet battery air open. 4, ready to remove the old UPS power battery, the battery shelf is removed from top to the next section, remove a screw to connect the connecting line to the electrical tape, do an insulation, pay attention, this step is very important, Don't be lazy, prevent the positive and negatives from taking short-circuit current, while electric shock is dangerous.

5, the UPS power storage battery is all removed, put it, start installing new batteries. 6. Press the battery number from the first beginning, start installation, position direction and removal of the old battery from the bottom layer of the battery holder, the joint screws must be tightened, the cable is neat, and the battery should be left with appropriate voids, minimum about about 25mm connection process strictly prevents short circuit.

7. After the UPS power battery is installed, verify that the positive and negative connection is correct, measure the total voltage, and confirm that the battery installation connection is correct. 8.

According to the battery parameters, calculate the charging voltage, measure the UPS output charging voltage, comply with the charging requirements of this batteries, close to the battery cabinet, check the host charging menu, the battery is already charged. 9, install the UPS power battery cabinet, turn back the UPS host into the market, confirm that the UPS host inputs the output voltage normally. Stop the generator, remove the cable, pack the tool, put the old UPS battery to the car, clean up the clean.

.