+86 18988945661 
contact@iflowpower.com 
+86 18988945661
Language
+86 18988945661 contact@iflowpower.com +86 18988945661
Author ：Iflowpower – Portable Power Station Supplier
The garden light is a separate self-powered system. When installing the solar-free maintenance battery, it must be gently put into the control box, prevent damage to the control box; the cable between the battery must be pressed in the battery with bolts. On the terminal, the copper gasket is used to enhance its conductivity; the output line is connected to the battery, and the short acceptance is prohibited in any case, prevent damage to the battery, the output line of the battery is connected to the controller within the electric wire.
Threading tube by PVC. After completing the above steps, check the connection of the controller, prevent short circuits, and close the door of the control box. Installing the solar garden lamp, requires the components of each part to fix: the solar panel is fixed on the solar panel holder, the lamp is fixed to the arm, then secure the bracket and the arms to the main rod, and transmit the cable to control Box (battery box).
Before the light pole lifted, check if the fasteners of each part firm, the lamp is installed, whether the light source is working properly. Then in the debugging system works normally, loosen the controller on the controller, the light source is working properly, and the light source is working properly, and the solar panel cable is turned off; at the same time carefully observe the changes in the indicator light on the controller, so data belongs to Normal, can lift the installation. When the main light pole lifted, pay attention to safety, the screw must be tight, such as the component as a row of sun, and adjust its Chaoyang direction completely toward the south.
Put the battery in the battery box, follow the technical requirements to connect the cable to the controller, first pick up the battery, then load the load, and then pick the solar panel; when the wiring operation, pay attention to the wiring terminal indicated on each channel and the controller cannot be Nether wrong, the positive and negative two poles cannot collide, can not be reversed, otherwise the controller will be damaged. Whether the debug system is performed normally; loosen the solar panel cable on the controller, the solar garden light is on, and the solar panel cable is connected, the light is extinguished; at the same time, carefully observe the changes in the indicator light on the controller, so The data is normal, and the control box can be sealed.
Copyright © 2024 iFlowpower - Guangong iFlowpower Technology Co., Ltd.
