18650 lithium-ion battery and lithium ion battery pack repair method

　　Author ：Iflowpower – Portable Power Station Supplier

18650 Lithium Ion Battery Repair Measures 1, remove your battery, remove it, solve it with temperature, the battery will greatly shorten the usage time in the case of temperature unstable, because the battery is no electricity and a considerable part of the lithium ion already With memory, this method can be used to release the memory, in winter, put it outside for a while, then go to the house. 2, remove the lithium ion battery, put a week, will slowly consume the electricity, and then take the machine to completely consume the electricity. Then all rinters, I will definite the charging time of your present, it is definitely very short, after the fullness, disconnect, repeated a few times, absolutely effective.

Lithium ion battery pack repair Measures lithium ion battery pack .jpg ◆ Discharge lithium ion battery packs can take boot discharge or electrical resistance. The power-on discharge should be placed to the extent to which the phone is turned on; the electrical resistance is charged can take the small-time discharge to connect the corresponding voltage until the small electric bead is connected to the extent to which it is extent.

The discharge current is preferably a large current. ◆ Activate the serial 12V AC power, and a small electricity or resistor is also connected in series between the lithium-ion battery pack for current limiting. First, small current activation is activated, so that the control circuit alternating current is tens of millimeters, maintained for 30 to 60 minutes, and then increase the current to the nominal value of the battery 1 to 2 times.

◆ The lithium-ion battery pack that will be exhausted is actually the end of its internal lithium battery. Therefore, we can reach the lithium-ion battery pack to reach a newborn as long as we replace the internal lithium battery. The detailed operation is as follows: Cut the seam along the battery housing with the US worker knife, if you do not resolve the hook buckle, wait for the rest then open, then pinch the housing on the side of the hook to make the snap open.

After opening the housing, remove the lithium core with the electric soldering iron, and then use this to purchase the corresponding specifications and quantity of lithium battery in the sample to the electronic market. Then, the newly purchased lithium battery is supplied to the original battery according to the original, and then coated with the hot melt glue of the fused state in the battery seam, then quickly, align and press the outer casing, and the pod is solidified after heat melt adhesive. The knife is trimmed from the seam spilled heat, and the lithium ion battery pack is completed.