Maintenance and maintenance introduction of 12V lithium iron phosphate ion battery pack

Auctor Iflowpower - Portable Power Station supplementum

● After completing the battery installation, before the battery is installed, the battery should be filled with the battery before discharge, and then use it. After the battery is fully charged and discharge, the battery can reach the maximum capacity. ● When the battery is low, it should be charged in time, which will benefit to extend the battery life.

If it is not charged in time, the battery will affect the battery life in a long time. If the battery is taken for a long time, it is best to make the battery in a half-electric state, and charging the battery once every 2 months, the charging time is one hour. ● The battery should be installed in air circulation, dry, clean environment; when charging, the fire source should be guarded, and the flammable items are close to and disconnected (enclosed electrical equipment).

● The operating ambient temperature of the battery is 5 ~ 40 ° C (the best working ambient temperature is 15 ~ 35 ° C). If this temperature range, the battery performance may vary, and the intuitive performance is battery capacity, or equipment Operation time changes, this is a normal phenomenon. ● Clean battery housing using an organic solvent.

When the battery is accidentally fired, carbon dioxide can not be used, but the fire extinguishing appliance or sand extinguishing of carbon tetrachloride should be used. ● The battery is a consumable product, and the life of the battery is limited. Please replace the battery in time when the battery capacity is less than 80% of the rated capacity.

Charger uses appropriately reasonable charging to extend the life of the battery pack, and the barbaric charging will have a great impact on battery life. The lithium ion battery pack is strictly prohibited from charging from the discharge junction, and it is not necessary to use a special charger to charge from the charging socket. If the original charger is broken, it is best to buy the original model of the charger.

The original prototype is always more suitable for more secure. 当充电器上的充电指示灯停止滚动时，应及时拔下充电插头，避免电池过充。